Hired-hand Mega Flow SlantWall Fans: 48 Aluminum Shutter Spri Uživatelský manuál stáhnout pdf

HIRED-HAND, INC. • 1733 Co Rd 68 • Bremen, AL 35033 • Phone 1-800-642-0123 • Fax 256-287-2000

Part No. 4801-5205 Page 1 of 2

Purpose

To add spring tension to an existing aluminum shutter for more efficient operation.

Tools Required

Cordless Drill 1/4” drill bit Kit of Parts

¼” hex head bit Screwdriver Pop Rivet Gun

Directions

(1) Open the Kit of Parts and verify that all parts are present.

See Figure 1.

(2) Remove the shutter from the fan and place the exhaust side

down on a flat level surface. NOTE: The shutter should be fully closed during installation.

Warning

Before beginning Installation disconnect all

electrical power from the fan.

48" Aluminum Shutter Spring Kit

Figure 1 Kit of Parts

Pop Rivets

Spring

Bracket

Spring Tensioner

Center Vane

Assembly

Vain Rail

Assembly

Pre-Drilled Holes

Rivet

Figure 2 Aluminum Shutter

(3) Locate the four holes in the shutter as shown in Figure 2.

The two top holes are in the left and right Vain Rail Assembly

and are pre-drilled. The two bottom holes are in the left and

right Center Vane Assembly and contain rivets. The two top

holes will hold the “U” Bracket installed in Step 6 and the

bottom two holes will contain the Spring Tensioner installed

in the next step.

1 2

HIRED-HAND, INC. • 1733 Co Rd 68 • Bremen, AL 35033 • Phone 1-800-642-0123 • Fax 256-287-2000 Part No. 4801-5205 Page 1 of 2 Purpose To

HIRED-HAND, INC. • 1733 Co Rd 68 • Bremen, AL 35033 • Phone 1-800-642-0123 • Fax 256-287-2000 Part No. 4801-5205 Page 2 of 2 (4) Using a ¼”

Žádné komentáře

Hired-hand Mega Flow SlantWall Fans: 48 Aluminum Shutter Spri Uživatelský manuál