Hired-hand Mega Flow SlantWall Fans (ASSEMBLED) Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Větráky Hired-hand Mega Flow SlantWall Fans (ASSEMBLED). Hired-Hand Mega Flow SlantWall Fans (ASSEMBLED) User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 4
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
HIRED-HAND, INC. 1733 County Road 68 Bremen, AL 35033 PHONE 256-287-1000 FAX 256-287-2000
Manual Part No. 4801-5125 Rev 12-02 Page 1 of 4
MEGA FLOW FAN
(See Reverse Side for Framing & Shutter Installation Instructions)
1. Disconnect power source before installing or
servicing fan. Failure to disconnect power
source can result in property damage,
serious injury, or death.
2. When connected to an automatic controller,
FAN MAY START AT ANY TIME.
3. IMPORTANT! Before Operating Fan, Inspect
Fan For any Object That May Obstruct Blade
Rotation.
!
WARNING!
SLANTWALL
(ASSEMBLED)
BEFORE INSTALLING
1. Inspect fan for damage in transit. Check for
loose, missing, or damaged parts.
2. If there are any missing parts or if there is
any shipping damage, do not attempt to
operate fan. Contact your Distributor.
1. Read WARNING statements before proceeding.
2.
Blades, motor, and wire guards should be cleaned
periodically to decrease vibration and ensure
maximum fan life. Remove dirt with a dry brush or
compressed air. DO NOT SPRAY MOTOR WITH
WATER OR CLEANING FLUIDS.
3. Fan performance may be greatly reduced by
damaged or dirty shutter. Clean and inspect shutter
periodically to ensure maximum fan performance.
MAINTENANCE
When this fan is used in a life support ventilation
system where failure could result in loss or injury,
the user should provide adequate backup
ventilation, or accept the risk of such loss or injury.
IMPORTANT!
INSTALLATION
1. Fan should be securely mounted to wall.
Refer to mounting instructions on sheet 3
of this manual.
2. Fan is provided with wire guard for your
protection.
National safety codes require that guards
be installed if within 7 feet (2.1 m) of floor
or within reach of personnel or livestock.
3. If thermostat is used, connect fan power
cord to controller.
WARRANTY
Your Mega
-
Flow fan has been manufactured with the finest
materials and components available and is backed by a one year
warranty against electrical and mechanical defects in material and
workmanship. If this fan fails to operate during this period, return it
prepaid to place of purchase for repair or replacement without
charge at the manufacturer's option.
This warranty gives you specific legal rights and you may have other
rights that vary from state to state.
Zobrazit stránku 0
1 2 3 4

Shrnutí obsahu

Strany 1 - MEGA FLOW FAN

HIRED-HAND, INC. • 1733 County Road 68 • Bremen, AL 35033 • PHONE 256-287-1000 • FAX 256-287-2000 Manual Part No. 4801-5125 Rev 12-02 Page

Strany 2 - FRAMING INSTRUCTIONS

HIRED-HAND, INC. • 1733 County Road 68 • Bremen, AL 35033 • PHONE 256-287-1000 • FAX 256-287-2000 Manual Part No. 4801-5125 Rev 12-02 Page

Strany 3 - MOUNTING INSTRUCTIONS

HIRED-HAND, INC. • 1733 County Road 68 • Bremen, AL 35033 • PHONE 256-287-1000 • FAX 256-287-2000 Manual Part No. 4801-5125 Rev 12-02 Page

Strany 4 - SHUTTER INSTALLATION

HIRED-HAND, INC. • 1733 County Road 68 • Bremen, AL 35033 • PHONE 256-287-1000 • FAX 256-287-2000 Manual Part No. 4801-5125 Rev 12-02 Page

Komentáře k této Příručce

Žádné komentáře